Rear oil seal | 050209083

The oil pressure relief valve 140036220 helps to ensure the right amount of oil is available at every phase of engine operation. When the engine is cold, more oil is allowed to flow to protect the bearings as oil is cold and thick. As the engine heats up, the oil becomes thinner, and the valve reduces the flow. Preventing too much oil flooding the engine parts and spraying onto the cylinder walls, resulting in reduction in overall engine power and excessive oil consumption. Oil relief valves are selected to ensure your Perkins engine consumes the least oil and operates effectively.

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

Filters or strainer 110666060 designed to be installed on the inlet side of the fuel pump to remove the debris that could damage the fuel pump, but not cause a reduction in pressure that could lead to cavitation and damage to the fuel pump. These filters have larger micron ratings than the main or secondary fuel filter.

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

Spin on oil filter 140517050 for Perkins engines, designed to meet the needs of Perkins engines by providing superior protection against particles that can make their way into the lubrication system during service or from component wear. Increasing emissions levels has resulted in more precise engineering tolerances in galleries and channels leaving less room between engine components than before, so choosing a genuine Perkins filter is more important than ever to ensure effective lubrication and cooling. Designed to reduce resistance to oil flow while maximizing filter efficiency and provide protection to the recommended oil service interval in the Operation and Maintenance Manual. Typically fitted with anti-drain back valve and by-pass valve to ensure the engine oil is in the right place during starting and operation. Supplied complete with sealing ring.

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

Perkins v-belts, also known as vee belts or wedge belts 2614B644, are designed to prevent alignment and slippage problems. With greater load, the belt will tend to wedge into the groove, providing better performance. Widely used due to the strength and reliability from fiber reinforcement. When replacing fan belts check the belt tension is correct, together with all the electrical connectors and the battery. Where engines have twin belts, check to ensure the belts are of a matched length.

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov